Glacier Blast offers a cleaning service for fire, smoke and soot damage. Give us a call at 320-275-5479Tweet
You've had a fire. The fire department has come, put the fire out and all you see is one big mess. Upon closer investigation questions come.
I. What cleaning method do we use to remove the soot and charcoal to evaluate the fire damage?
- High pressure water blasting leaves behind water in electrical components, equipment and insulation, if not properly removed will cause unwanted corrosion and rot, increasing cleanup, damage and long term maintenance costs.
- Sand and soda blasting leaves abrasive blast media behind, which if not cleaned up properly continues to cause damage in electrical components, gears and bearings. It continues to fall from horizontal surfaces, cracks and beams years after the job is done, increasing cleanup, damage and long term maintenance costs.
- Dry ice blasting is the best fire damage cleaning process, it leaves no secondary waste stream behind. The only cleanup after the job is done is the removal of the debris caused by the fire.
II. How do we remove the soot, charcoal and smoke film from masonry and steel surfaces?
- Again this is an excellent application for dry ice blasting. Watch the videos on our "Videos" page,to see how it cleans soot, smoke and charcoal from different types of surfaces.
III. Will we be able to remove that awful smoke smell?
- The removing of the smell is accomplished by removing the smell source and/or sealing the smell source to encapsulate it. Dry ice blasting removes the soot, charcoal and smoke film, which is the smell source, from accessible areas.
- During a fire air currents carry smoke and soot into cracks, openings and areas not in close proximity to the fire itself, additional cleaning and/or sealing of these places and inaccessible areas may be needed.
IV. Can we accomplish our fire damage cleanup without adding hazards to our environment?
- Dry ice is CO2 in its solid state. CO2 is safe and environmentally friendly. It is in its gaseous state in the air around us. When we inhale our bodies use the oxygen and we exhale CO2. Green plants take CO2 from the air and give off oxygen.
- This industrial cleaning process is non-toxic, non-conductive and there is no employee exposure to hazardous cleaning chemicals or solutions. It meets the guidelines of the USDA, EPA, and the FDA.
Industrial Cleaning By Dry Ice Blasting In Minnesota